Rigid member collar kit made by Odula of Japan. Designed for the ND Miata, these member collars help to fill in tiny spaces between the suspension member and body of the vehicle to increase rigidity. These also increase handling capabilities!
Learn More
Urethane bushing kit for the ND Miata made by Odula. This bushing kit replaces the stock rubber bushings in the rear knuckle to cancel out minor toe alterations during bumps and shudders to the suspension system.
Learn More
4 point roll cage by Saito of Japan for the ND Miata. This roll cage will not only provide a healthy amount of rigidity to the ND body, it will also make your Miata safer in the event of a roll. The standard kit is a 4 point setup, with optional add on bars available. The kit is also available in three different materials to fit a variety of budgets. The roll bar comes unassembled without pads.
Please contact us for shipping quote prior to ordering.Learn More
Rear Rigid Collars manufacturer and patented by Spoon for the ND Mazda MX-5 (2016+). It is a full set (front and rear) made of 24 pieces. These pieces install between the body and subframe to reduce the little gap that will cause low-level vibrations and reduce overall rigidity of the car.
The Rigid Collars will :
-Reduce pull-up/oscillation during engine start up
-Vibration is reduced during idling
-Straight line stability is improved
-Steering adjustment is reduced
-Rolls smoother & reduce fatigue during driving
In other words, it'll improve the ride greatly.
Please note that photo is not the actual product, but a rendition of it.Learn More
Rear strut bar made by Tuckin99 of Japan for the 2016+ ND MX-5. Widely used in automotive tuning, a strut tower bar will connect the left and right sides of the vehicle together to stiff-en the car up and improve handling. This bar is for the rear.
Please note that during installation trimming of the OEM trunk liner is required for install.
Learn More