Air Intake for the NA (1989-1997) Headlight Lid made by Zeromotive to help engine cooling. It has a nice aggressive look and is available for both headlight sides! Before painting, please make sure the product fits the car properly. Learn More

Product made by Zeromotive. The front canards flows well with the OEM bumper, giving downforce and aggressive look. Available in LONG and SHORT version, both are very similar but can be seen from pictures. It comes with screws. The only tool you need is a screwdriver, and you don't have to make the pilot holes in advance because the genuine bumper is made of urethane. Learn More

Body part guard made by Silk Blaze & Zeromotive of Japan. This part is a MUST have for those with extremely low vehicles, or for those with low-hanging aero parts. With a very low car, even small changes in elevation can cause you scrape the front, rear, or even the side skirts of your car. The aeroguard material attaches below the aero parts using durable 3M double sided tape and will provide a soft cushion and protect the finish of your cars body components. 1 roll is 29mm x 4mm x 3m The aeroguard material attaches extremely easily; simply clean the part you wish to attach it to, peel back the adhesive cover and apply! If you wish to wrap the material around a corner, simply cut little triangles into the material for a smooth, even angle. Learn More

License Plate Holder (Relocator) that is sideway made by TUCKIN99 for the NA (1989-1997) & NB (1998-2005) MX-5 Miata. It’ll move the license plate to the side so that the radiator becomes unobstructed and gets more fresh air. Please note that if your license plate has different hole size than Japan, some drilling (additional holes) might be required. Learn More

Product made by TRAP. A Simple, yet effective piece made by TRAP. This flush rear panel replaces your stock finish panel with ease. Would compliment a shorty rear bumper beautifully. Please note that there might be an extra fee to ship this product to some countries due to Japan Post EMS size limitations. Read more.

Learn More

Rear finish panel made by TRAP out of quality FRP. A Simple, yet effective piece made by TRAP. This mesh rear panel replaces your stock finish panel with ease. Learn More

Hard top duct from TRAP of Japan for the NA Miata that is based on the design used on Mazdaspeed Hardtops. This duct for the hard top works to draw outside air in to the cabin or let air out of your cockpit. The duct utilizes partitions within the unit in order to allow the user to either let air in or out of the cockpit. A hard to find part from Japan that will be sure to make your NA stand out. Learn More

Product made by TRAP. Made from high quality FRP. While eliminating the third brake light, TRAP's flat trunk gives the rear end a sleek look. Learn More

Increase the exterior appeal of your NA, NB, or NC Roadster (1989-2015) with the Shinkai Plated Wiper Blades. The OE replacement wiper blades feature high-quality plating that is available in silver plating or smoke plating. The Shinkai Wiper Blades are directly compatible with NA and NB Roadsters, for use with the NC chassis you will need to reuse the metal retainers. Allows the customer to use genuine wiper blade rubber. Learn More