License Plate Holder (Relocator) that is sideway made by TUCKIN99 for the NA (1989-1997) & NB (1998-2005) MX-5 Miata. It’ll move the license plate to the side so that the radiator becomes unobstructed and gets more fresh air. Please note that if your license plate has different hole size than Japan, some drilling (additional holes) might be required. Learn More

Product made by TRS. Available in plenty of colors and solid enough to be used for emergency. It is an universal part that requires a custom mount/bolting to the factory tow hooks. Learn More

Product from JAPAN made by TRAP from high quality FRP. Gives a subtle but noticeable change to the look of the car by making it more aggressive. Please note that there might be an extra fee to ship this product to some countries due to Japan Post EMS size limitations. Read more.

Learn More

Product made by TRAP. A Simple, yet effective piece made by TRAP. This flush rear panel replaces your stock finish panel with ease. Would compliment a shorty rear bumper beautifully. Please note that there might be an extra fee to ship this product to some countries due to Japan Post EMS size limitations. Read more.

Learn More

Rear finish panel made by TRAP out of quality FRP. A Simple, yet effective piece made by TRAP. This mesh rear panel replaces your stock finish panel with ease. Learn More

Product from JAPAN made from high quality FRP. Original product made by TRAP. It gives the capacity to run wider wheels with lower offset and larger tires on your roadster without compromising the look of it! Confirmed wheel fitment from TRAP : 14x9 -19 Front / 14x10 -20 Rear. 15 inches not tested but should work fine.Depending on tire size, there may be some interference. Learn More

Hard top duct from TRAP of Japan for the NA Miata that is based on the design used on Mazdaspeed Hardtops. This duct for the hard top works to draw outside air in to the cabin or let air out of your cockpit. The duct utilizes partitions within the unit in order to allow the user to either let air in or out of the cockpit. A hard to find part from Japan that will be sure to make your NA stand out. Learn More

Product from JAPAN made by TRAP from high quality and flexible FRP. Gives a noticeable change to the look of the car by making it more aggressive. Please note that there might be an extra fee to ship this product to some countries due to Japan Post EMS size limitations. Read more.

Learn More

Flush & sleek rear bumper made by TRAP to give the NA Miata (1989-1997) very different look from the back. It is an original design by TRAP that makes the bumper sit flush with the trunk. It is all shaved for a very neat look. Learn More