Front lip made by Garage Vary for the NC3 (2013-2015) MX-5 Miata to improve looks and make the bumper look lower. It flows very well with the lines of the vehicle and gives a nice and bold front look. It’s also available with an optional front splitter. Learn More

The Garage Vary Nostalgic Tail Lamp Panel is made for NA (1989-1997) MX-5 Miata. This is a brand new, made in FRP, product from Garage Vary in Japan. This product DOES NOT include any tail lamps, it is for the panel. You will need to source the tail lights & back lamp by yourself (sold optionally). If you want a complete kit, please look for the Garage Vary DIY Tail Light Kit or the GV x REV9 LED Tail Light Kit. Please note that there might be an extra fee to ship this product to some countries due to Japan Post EMS size limitations. Read more.

Learn More

GT Wing designed by Garage Vary for the 2016+ ND MX-5 to improve lap times during Japan’s Roadster Cup (N-Zero Class) which only allows aerodynamics and suspension modification (no engine upgrades allowed). This GT Wing mounts on the trunk but also overlaps on the quarter panel because it’s more rigid than the flimsy OEM aluminum trunk. The position of the mounts also allows the use of trunk without any problem. It has been tested a lot at Fuji Speedway with constant improvements when using the trunk versus not using it.

This GT Wing needs to be used with a Short Antenna (or no antenna) as the OEM antenna will be in the way. Learn More

GT Wing made by Garage Vary for circuit use on their NC demo car. The wing itself is made of FRP and the end-plates (sides) are made of Carbon Fiber. It’s made to improve downforce of the MX5 by a lot. Learn More

Product from JAPAN made from high quality and light CARBON FIBER. Keeps the cold air at the radiator instead of letting it escape over the top. Learn More

Ram air intake (duct) kit for the NC MX-5 (2006-2015) Miata made by Garage Vary. By forcing air to the OEM intake, the intake is able to make more power and increase throttle response. This will fit the OEM front bumper and will be hidden once the bumper is installed. Learn More

Rear air vent by Garage Vary, one of the top companies in the current F.R.P. and carbon body parts market. Made specifically for the ND (2016+) Mazda Miata/MX-5, these ducts allows for more airflow underneath the car as well as allowing the turbulent air to exit out of the wheel wells. This causes less drag on the Miata during hard driving and also has the benefit of helping the brakes components cool down. The kits comes in a set of two for the left and right side and gives the Miata a more aggressive look. Learn More

Garage Vary Rear Blister Fenders for the ND (2016+) MX-5 Miata. If you’ve been looking to add a noticeable increase in width to the rear end of your ND – check out these Blister Fenders! These Blister Fenders provide an extra 9mm of width per side, allowing for chunkier or more aggressive wheel setups. Garage Vary has modelled these to not interfere with the factory Blind Spot Monitoring system, so you can keep the safety features of your car in place. Please note installation of these Fenders will involve drilling into the rear quarter panels of your car, and that these Fenders are only compatible with the factory rear bumper. Aggressively stylise and change the presence of your car on the road! Learn More

Rear diffuser made by Garage Vary. It's available with 3 variations : diffuser only, diffuser + center flap & diffuser + slit spoiler. It helps improve downforce. Cutting to the bumper is required to install this part. Learn More