Front license plate relocation kit made by Tuckin99 for the 2016+ ND Miata. This kit relocates the number plate to the side of the Miata for both a stylish look, and increased cooling capabilities by not having the license plate impede airflow to the radiator. It installs using front tow hook hole and will not require any cutting or drilling. Please note that you need to drill 2 additional holes to fit US plates. Learn More

License Plate Holder (Relocator) that is sideway made by TUCKIN99 for the NA (1989-1997) & NB (1998-2005) MX-5 Miata. It’ll move the license plate to the side so that the radiator becomes unobstructed and gets more fresh air. Please note that if your license plate has different hole size than Japan, some drilling (additional holes) might be required. Learn More

Lightweight Fly Wheel made by TUCKIN99 for the 2.0L NC (2006-2015) MX-5 Miata. TUCKIN99 tested many flywheels weight to find the perfect balance between performance and reducing idling roughness. Learn More

This part will start the water cooling flow earlier (71 degrees Celsius) in order to prevent engine overheat on the NA or NB MX-5 Miata (1989-2005). The lift amount is actually higher than normal to prevent foaming of cooling water, making it suitable for circuit driving. Learn More

Product from JAPAN made from high quality FRP. Replica of the well known Mazdaspeed N2 Flares. This item is made by TUCKIN99. It gives the capacity to run wider wheels with lower offset and larger tires on your roadster without compromising the look of it! Example of confirmed fitment with these flares is 15x8.5 -5 offset with 225/50R15 tires. Learn More

Fender Flares for NB1 (1998-2000 Mazda MX-5 Miata) made from high quality FRP. Original product made by TUCKIN99. It gives the capacity to run wider wheels with lower offset and larger tires on your roadster without compromising the look of it! The wheels on the white car are RAYS TE37V 15x8 +0. The front wheels have 10mm spacer making them -10mm offset and the rear wheels have 20mm spacer making them -20mm offset. The wheels on the green car are XXR in 15x8.25 +0 with 15mm spacer in the rear making it -14 offset. Tires used are 205/50R15. Learn More

Product from JAPAN made by TUCKIN99. Subtle and stylish touch to the exterior. Makes the bumper look more aggressive and lower. Learn More

Rear bottom skirt from TUCKIN99 in collaboration with Chargespeed for the 2016+ ND MX-5. It has a very near look and will totally compliment the rear bumper of the fourth generation Miata. Please note that the Carbon Fiber finish is not UV coated and it is recommended to have it coated locally if you park the car under the sun most of the time. Learn More

Rear strut bar made by Tuckin99 of Japan for the 2016+ ND MX-5. Widely used in automotive tuning, a strut tower bar will connect the left and right sides of the vehicle together to stiff-en the car up and improve handling. This bar is for the rear. Please note that during installation trimming of the OEM trunk liner is required for install. Learn More